Achieve a flawless, salon worthy look in minutes.
BOND & SEAL CLUSTER APPLICATION
Applying your Milarēs Seamless Cluster Lashes is quick, simple, and beginner friendly.
Follow these steps to create a weightless, natural finish that lasts — all from the comfort of home.
Ensure your natural lashes are clean, dry, and free from any oils or makeup. This helps the bond adhere seamlessly.
For best results, curl your natural lashes before application to help the lash clusters blend seamlessly and sit flush beneath the lash line.
Brush a thin coat of bond to the underside of your natural lashes from root to mid length. Avoid coating the tips.
Do not apply like mascara. You only want the bond at the base ot your lashes.
Using your applicator, pick up the first lash cluster and place it underneath your natural lashes, starting from the outer corner. Continue inward until the look is complete.
When applied correctly, you should not feel the clusters at all. Avoid making contact with your waterline — the lash clusters should sit directly above it. If you feel the clusters, use the applicator to gently pull the lash cluster a little higher.
It helps to pull your lid up so that you can easily see where to place each cluster. (See video above)
Slightly overlapping your clusters will also help with retention, because if one cluster lifts slightly, it's going to be secured to another.
Apply a light layer of seal to the base of the lashes where you applied the bond to lock them in and extend wear time.
For an even more secure hold. lightly coat your lash curler (top and bottom) with sealer, and gently clamp your lashes as close to the roots as possible.
For best longevity, avoid water or steam for the first 24 hours after application and excessive exposure to oils.
PRESS ON LASH APPLICATION
Your easiest lash routine yet.
Ensure your natural lashes are clean, dry, and free from oils or makeup. This helps the pre applied adhesive grip securely and wear smoothly.
Carefully remove the lash cluster using our non stick applicator, avoiding the band as this is where the adhesive it (it's very sticky).
Lift your upper lid to expose your lash line, and starting from the outer corner, apply each cluster just above your lash line in an upward motion — you will feel it grab onto your natural lashes.
Gently clamp your lashes with the lash applicator. For an even more secure hold, gently clamp using a lash curler.
Wear & Removal
LASH CARE
- Avoid oil based products around the eyes and keep the lashes dry for the first 24 hours after application
- Cleanse lashes gently using a cotton tip and water based cleanser to avoid build up from day to day oil build up
Yes — the lashes are waterproof. For best longevity, avoid water or steam for the first 24 hours after application and excessive exposure to oils.
- Apply to clean lashes free from any makeup and oils
- Use your lash curler to clamp your clusters for a secure hold
- Allow the adhesive to fully set and avoid water or steam for the first 24 hours
- Avoid rubbing your eyes, and handle the lashes gently to maintain their hold
Removal
Apply remover along the lash line and allow it to break down the bond. Once loosened, gently slide the lashes away — avoid pulling.
Allow the remover to sit for approximately 1 minute so the bond can fully break down before removing the lashes. They should then easily slide off without damaging your natural lashes.
Need help?
If you’re new to using cluster lashes or press ons, allow a few attempts to find your rhythm. Once familiar, the process becomes quick, seamless, and second nature.
If you need guidance at any stage, feel free to reach out — we’re here to help.